Application of TB4420 (5.5W) audio power amplifier circuit

High-power led lamp beads 1W white light Sanan 30mil high power LED lamp beads imitation lumens

Shunluo Inductance Power Inductor SWPA Series First Class Agent

Probe domestic high frequency needle JKT-50L high frequency needle with 3 probes

Crystal oscillator 2.5*2.0mm 2520 0.67M~170M OSC can be supplied at any frequency

The TB4420 power amplifier circuit is a high-gain, low-noise, high-power amplifier circuit. The circuit is internally provided with a signal cut-off type load short circuit protection circuit. A load impedance of 2 ohms can be used. The output power is large, the voltage gain is high, the harmonic distortion is low, and the output noise is small. Therefore, it is suitable for car radios, audio players, portable, desktop recorders, etc. The shape is a single-inserted 10-pin plastic package with a heat sink. This circuit is directly interchangeable with the LA4420 produced by Sanyo Electric Co., Ltd. of Japan. At present, there is a production of Tianjin Semiconductor Equipment Factory. The main electrical parameters of TB4420 are as follows: no signal current: 50mA, voltage gain: 50dB (RNF=62Ω); output power: 5.5W (RL=4Ω); harmonic distortion: 0.3%; input impedance: 20KΩ; output noise voltage: An application example of the 0.6mVTB4420 audio power amplifier circuit is shown in the figure. The static voltage of each foot of TB4420 is shown in the table, Vcc=13.2V.
Using two TB4420 integrated circuits to connect to a BTL audio power amplifier can more than double the output power. The wiring diagram is shown in the figure.
TB4420 integrated circuit application notes (1) The voltage gain of this circuit depends on the external feedback resistor RNF, RNF ↑, gain ↓, and vice versa.
(2) Frequency response characteristics, the lowest cutoff frequency depends on C3, C4, C5, RNF and RL, while the high-end phase compensation depends on IC5 and 5 pin capacitors.
(3) C1, C2, C11, and C12 are compensation capacitors that prevent self-oscillation in the high frequency band. It is preferable to use a polyester film capacitor. If a ceramic capacitor is used, self-oscillation is likely to occur due to poor temperature performance.