Spike Audit Bureau: "Guangzhou Optics Valley" occupancy rate is less than 20%

At the beginning of this month, Guangzhou re-launched “Guangzhou Optics Valley” with high-profile, saying that the output value of the light industry is expected to exceed 360 billion yuan in four years. For the LED and lighting industry, which is the mainstay of “Guangzhou Optics Valley”, the industry has been worried about overcapacity. On September 24, the audit results of the Guangzhou Municipal Audit Bureau showed that as of June last year, the occupancy rate of the Guangzhou International Commodity Exhibition and Trade City Phase I project (“Guangzhou Optics Valley” project) was only 18.96%.

On September 3, the “Guangzhou Optics Valley” kick-off meeting was held. Guangzhou Municipal Party Committee Secretary Wan Qingliang and Mayor Chen Jianhua attended the meeting and invited five academicians in the field of optics to jointly kick off the "Guangzhou Optics Valley". According to the meeting, the output value of Guangzhou's light industry in 2016 should exceed 360 billion yuan.

However, three days ago, Zhang Jieming, director of the Guangzhou Municipal Audit Bureau, reported to the Guangzhou Municipal People's Congress a series of audit questions on the International Commodities Exhibition and Trade City.

The audit results show that the exhibition and trade city project failed to complete the construction scale target proposed in the feasibility study report; after the construction scale was reduced, the expected construction target was still not achieved. The audit also found that the operation and operation of the exhibition and trade company was not standardized, and the investment and income of the project did not match. As of June 2012, the occupancy rate of the exhibition city project was only 18.96%, and the occupancy rate did not reach the target; the company continued to lose money and the operation faced Seriously difficult.

( This article is reproduced on the Internet. The texts and opinions expressed in this article have not been confirmed by this site, nor do they represent the position of Gaogong LED . Readers need to verify the relevant content by themselves. )

Medical Device Wire

Medical Device Wire :The key requirements of modern medical connector include safety, reliability, small size and high speed performance. Since it is a small component in the overall design of any medical device, it can be considered that the connector is an important part of the medical equipment.

Common BV, RV line series

Silicone rubber insulated high temperature wire agr

High temperature braided wire AgRP with silicone rubber insulation and glass fiber

Silica gel high temperature control cable

Silicone rubber high voltage line agg 1kv-100kv

Teflon high voltage line 1kv-100kv

PFA Teflon insulated wire

FEP fluoroplastic high temperature line

PTFE fluoroplastic high temperature line

High temperature resistant control cable with Fluoroplastic insulation and sheath

Fire resistant and flame retardant control cable with PVC insulation sheath

Fire resistant line gn500 degree

Medical Device Wire

ShenZhen Antenk Electronics Co,Ltd , https://www.antenksocket.com

Posted on